Tank Prep and Sealer - RED-KOTE

Coating a fuel tank should be a simple and easy process. Introducing RED-KOTE® Fuel Tank Sealer and Liner.  The only choice for sealing up that rusty old fuel tank sitting on your dream machine.

Red-Kote® is an internal fuel tank liner designed to seal leaks and prevent further rusting. As a sealant - Red-Kote® excels at sealing the often hundreds of pin-hole leaks that occur along seams or where straps wrap around the tank. Once in place - Red-Kote® forms a very tough / flexible membrane that will never crack or flake as many competitive products do. Red-Kote® will not plug lines or cause engine damage when used properly. Future rust will be prevented because condensation will not contact the metal. 

Simply remove your tank - drain the fuel - clean and etch the tank with our two part Kreem tank prep cleaner kit. Then dump half the can of RED-KOTE® Tank Sealer close the lid and roll it around coating the interior. That's it! 

Red-Kote® takes approximately eight hours to dry. It stays 100% flexible and will never crack or peal off the interior tank surface. It will find and fill all pinholes even covers rust should you fail to get it all out prior to coating. Make sure the pin-hole vent on the underside of your gas cap doesn't get coated - if it's plugged the fuel won't flow out of the tank properly.

What makes RED-KOTE® Tank Sealer different is that it's a solvent-based polymer coating which is resistant to gasoline / diesel fuel / alcohol and other fuel additives other coating solutions which require multiple parts to actually seal. It doesn't get any better than this folks.